To put the stem in the hole

Discussion on Stirling or "hot air" engines (all types)
Post Reply
Smith57
Posts: 5
Joined: Tue Mar 27, 2012 4:00 pm

To put the stem in the hole

Post by Smith57 » Tue Mar 27, 2012 4:06 pm

To paste this stem in the hole in the plate before so that just one / 8" to five / 32" of the point is proud surface. I made holes by the face out of wooden by the inside all of holes of support. Then I ran one "the screws length of head of pan by the second hole so the points of the screws surpassed three / 32" or less beyond the outer layer of the face out of wooden ( seven ).

Post Reply