RE-POST single piston hot air engine

Discussion on Stirling or "hot air" engines (all types)
Post Reply
DavesPlanet
Posts: 22
Joined: Thu Mar 14, 2013 9:38 pm

RE-POST single piston hot air engine

Post by DavesPlanet »

This is a re-post as the original post was just prior to the site being hacked and doesn't seem to exist any more.

See the animation below. Consider that as the air in the hot end heats up, the high pressure air forces in on the sealed displacement piston, and the flexible diaphragm will be forced to collapse, bringing the piston to the hot end of the cylinder, forcing the air to the cold end. As the air cools and contracts, the pressure drops, and the lower pressure causes the diaphragm on the sealed displacement piston to distend, forcing the cold air to the hot end. The linear oscillation would of course be used to drive a linear alternator, simplified in this diagram as magnets moving outside of a fixed coil.

There is no question that this design can forcefully shove the piston one way or the other as the temperature changes, the question is of oscillation. It seems to me that the mass of the piston would have the same effect as a flywheel, and that a forceful oscillation could be achievable. The specifics of the oscillation would certainly be determined by factors that include the mass of the piston and the density and composition of the working fluid.

Image

If you commented on this for the last post, I appreciate hearing from you again. Thanks!
Last edited by DavesPlanet on Sun Apr 07, 2013 8:38 pm, edited 1 time in total.
Chriske
Posts: 87
Joined: Sat Oct 02, 2010 1:24 am

Re: RE-POST single piston hot air engine

Post by Chriske »

thanks....
Mijn thuis is waar mijn draaibank staat...
fullofhotair
Posts: 265
Joined: Sun Aug 05, 2012 6:28 am

Re: RE-POST single piston hot air engine

Post by fullofhotair »

Is it wise to have a diaphragm in the hot end? Are you going to make a working model?
bigredlevy
Posts: 1
Joined: Sat Jul 06, 2013 4:16 pm

Re: RE-POST single piston hot air engine

Post by bigredlevy »

You could pressurise the inside of the displacer through the stem holding the coil
Changing pressure as the system heats up would mean the piston would not latch to one side

I wonder if this would work for a hot water engine (imagine hot air engine where hydraulic lock is an issue)
DavesPlanet
Posts: 22
Joined: Thu Mar 14, 2013 9:38 pm

Re: RE-POST single piston hot air engine

Post by DavesPlanet »

Perhaps a tiny calibrated leak to allow the two chambers to reach equilibrium as temperature increases to deal with the inconsistencies of real gas laws (as opposed to ideal laws which would maintain perfect equilibrium as the temperature of the two different size spaces averaged out).
Post Reply