I made a small stirling engine, but will it work, with video

[larsinist]

Hi all



I made a small stirling engine on my lathe,but there are not so much power in the diagram,should the regenerator be longer, or mabee my displacer is to heavy..it has a 23mm diameter bore, and it is 74mm long, and the piston is about 46mm long.and about 22mm in diameter.what you think,shall i build the rest of the engine, or should i start over again???

https://www.youtube.com/watch?v=Urzl2Iai038

Edited by Boydhouse:

[youtube]http://www.youtube.com/watch?v=Urzl2Iai038[/youtube]

Lars

[larsinist]

http://www.youtube.com/watch?v=ttlS1txVzxY

Edited by Boydhouse:

[youtube]http://www.youtube.com/watch?v=ttlS1txVzxY[/youtube]
now i just need to make the beam, i hope it will work.

Lars

[Ian S C]

Sorry Lars, I,v tried my dial up, and I'v tried broadband, I,v tried both IE, and Chrome, but I can't get your vidios.
Ian S C

[Ian S C]

Got it Lars, the fist video I think you could get a beam engine or similar to work from that. The 2nd one I think it nail or what ever you have attached to the piston is putting too much side load on , and jambing the piston, preventing it from moving, it may work vertically with no side load. you might need a bigger flywheel, probably make one larger in diameter, doesn't need to be much heavier.
Ian S C

[larsinist]

Thanks for reply ian, i have started on a new engine, i know that brass is not the best cylinder material, but i was i got,and i will make new parts in steel if it turns out good.this is the parts i have made now.

stirling brass.jpg (92.78 KiB) Viewed 4311 times

stirling brass3.jpg (85.54 KiB) Viewed 4311 times

stirling brass2.jpg (74.9 KiB) Viewed 4311 times

[Ian S C]

Lars, one of the reasons I don't use brass is it's cost here, I think the metal merchants think that it is gold.
Ian S C