Page 1 of 1

Metronome engine question

Posted: Tue Mar 01, 2016 8:31 am
by Crazyguy
This question is for those who have metronome Engine experience.
Q: Am I right in thinking that the heavier the displacer is (plus magnet) , the longer the hose has to be?
I would like to make some with linear alternators on the displacer shaft.
Q: Also can the hose be vertical (straight up) ?

I have only gotten the water piston version to work ( pringles can version) thanks to mrsamodelkin and it doesn't go fast.

Re: Metronome engine question

Posted: Tue Mar 01, 2016 1:46 pm
by tibsim
Q: Am I right in thinking that the heavier the displacer is (plus magnet) , the longer the hose has to be?
Yes.
Q: Also can the hose be vertical (straight up) ?
Yes.
"I have only gotten the water piston version to work ( pringles can version) thanks to mrsamodelkin and it doesn't go fast."
Engine is much better with air.

Re: Metronome engine question

Posted: Tue Mar 01, 2016 2:15 pm
by Crazyguy
@tibsim
Thank you.
I also think I may try magnet springs , might work to counter balance mass of magnet.
Thanks for speaking English, I appreciate it. I am only a one language person. Need to use google translator.

Re: Metronome engine question

Posted: Tue Mar 01, 2016 3:33 pm
by Crazyguy
@tibsim
It looks like the displacer has to be denser than most stirlings to assist to compress and rarify the air in the gas diode ?
Also more close fit to the cylinder?
What do I need to do to get the shortest hose? Smaller diameter?

Re: Metronome engine question

Posted: Wed Mar 02, 2016 4:35 am
by Crazyguy
Two things.

The hose on the metronome could be the long pre- coiled plastic air hose like the picture below.
Image


Question:
1. Could the long hose be replaced by a short pipe connected to a diaphram/ membrane to save space?

Here's my plan.
Image

Re: Metronome engine question

Posted: Fri Mar 04, 2016 2:21 pm
by tibsim
First engine always must be perfect same than description.
URL removed because of it's "anti-Semitic" views. Do not re-post.

Re: Metronome engine question

Posted: Fri Mar 04, 2016 3:05 pm
by Crazyguy
?

Re: Metronome engine question

Posted: Sun Mar 13, 2016 12:09 pm
by Crazyguy
Does anyone think this would work so there wouldn't be such a long hose?
Image