Discussion on Stirling or "hot air" engines (all types)
5 posts • Page 1 of 1
So I Recently Purchased A Stirling Engine From Sunny Tech And Trying To Run A Belt Over The Larger Flywheel To A DC Brush Motor To Push The Motor In Reverse To Attempt To Make A Generator Can Anyone Help Me With A Setup So I Can Get More Torque And Be Able To Push The DC Brush Motor Thanks!
https://www.amazon.com/Sunnytech-hot-St ... ing+engine Here is a link to the motor
I don't think you'll run the generator by driving it with the flywheel, it should run with the smaller pulley. Another thing you might try, Connect the generator to a battery, you should be ok up to three dry cells/4.5volts, and get the Stirling Engine turning over in the normal direction(no flame under it), leave it running quite fast for a few minutes, then feel the end where it is normally heated, it should be quite cool, maybe even a bit frosty, mean while the cold end cooling fins should have started to warm up. In industry large motors are run this way to produce liquid gas.
Ian S C
Ian S C
Who is online
Users browsing this forum: Baidu [Spider], Yahoo [Bot] and 50 guests