Crankshaft

Discussion on Stirling or "hot air" engines (all types)
Post Reply
shafiqmahadi90
Posts: 1
Joined: Tue Jan 24, 2017 8:31 pm

Crankshaft

Post by shafiqmahadi90 » Thu Feb 23, 2017 6:56 am

Hello everyone,

I was thinking to design Beta Type Stirling Engine with the crankshaft between Displacer and power Piston, i just want to save some space for the engine. If anyone have any idea how to design the crankshaft of this stirling engine. I design the basic 0 degree 90 degree and 0 degree again.

Thanks!







Sent from my Lenovo A5500-HV using Tapatalk

Ian S C
Posts: 2137
Joined: Thu Dec 02, 2010 5:15 am
Location: New Zealand

Re: Crankshaft

Post by Ian S C » Fri Feb 24, 2017 2:10 am

Sorry I don't have a good photo, this is the best I have of the crankshaft of my 1 3/4" bore x 3/4" power stroke, and 1 1/16" displacer stroke BETA motor. The power crank is in the shadow on the left, and the displacer rod and con rod / crank on the right.
And the motor its self, water cooled, 155 mm flywheel. Heated by gas.
Ian S C
[img]
Test 004 (640x480).jpg
Test 004 (640x480).jpg (137.09 KiB) Viewed 1166 times
[/img]

[img]
Test 004 (640x480).jpg
Test 004 (640x480).jpg (137.09 KiB) Viewed 1166 times
[/img].
Attachments
Test 002 (640x480).jpg
Test 002 (640x480).jpg (198.55 KiB) Viewed 1166 times

Post Reply