Page 1 of 1

Crankshaft

Posted: Thu Feb 23, 2017 6:56 am
by shafiqmahadi90
Hello everyone,

I was thinking to design Beta Type Stirling Engine with the crankshaft between Displacer and power Piston, i just want to save some space for the engine. If anyone have any idea how to design the crankshaft of this stirling engine. I design the basic 0 degree 90 degree and 0 degree again.

Thanks!







Sent from my Lenovo A5500-HV using Tapatalk

Re: Crankshaft

Posted: Fri Feb 24, 2017 2:10 am
by Ian S C
Sorry I don't have a good photo, this is the best I have of the crankshaft of my 1 3/4" bore x 3/4" power stroke, and 1 1/16" displacer stroke BETA motor. The power crank is in the shadow on the left, and the displacer rod and con rod / crank on the right.
And the motor its self, water cooled, 155 mm flywheel. Heated by gas.
Ian S C
[img]
Test 004 (640x480).jpg
Test 004 (640x480).jpg (137.09 KiB) Viewed 2108 times
[/img]

[img]
Test 004 (640x480).jpg
Test 004 (640x480).jpg (137.09 KiB) Viewed 2108 times
[/img].