What fastener to use on Hot Cylinder?

Discussion on Stirling or "hot air" engines (all types)
DangerouslyExplosive
Posts: 2
Joined: Sat Feb 03, 2018 3:36 am

What fastener to use on Hot Cylinder?

Postby DangerouslyExplosive » Sat Feb 03, 2018 8:52 am

Hello all,

I have had a sterling engine (which I got on Amazon) for a couple of years now, and whatever was holding the Hot Cylinder (glass tube) in place on the metal bit has finally decided to crack. Consequently, my engine no longer runs. I've been looking around, but I can't seem to find out what kind of glue, o-ring, or fastener I am supposed to use to re-attach the hot cylinder.

Attached is a picture of the hot cylinder and it's mount.

Picture 1.png
Photo of hot cylinder and mount.
Picture 1.png (251.17 KiB) Viewed 107 times


Any idea what I should use?

Trevor
Posts: 176
Joined: Sun Nov 06, 2016 4:07 am

Re: What fastener to use on Hot Cylinder?

Postby Trevor » Sat Feb 03, 2018 5:41 pm

I would use high temp silicon (red). It comes in a handy tube and you can purchase from any bearing, engineering or even Bunnings stores.
Glass does not transmit heat readily so the adhesive will wok here quite well.
Trevor

Marnurss
Posts: 1
Joined: Mon Feb 12, 2018 7:56 pm

Re: What fastener to use on Hot Cylinder?

Postby Marnurss » Mon Feb 12, 2018 8:04 pm

A very interesting experiment.


Return to “Stirling and "Hot Air" Engine Forum”

Who is online

Users browsing this forum: Alfista and 36 guests