DISPASER QUESTION

Discussion on Stirling or "hot air" engines (all types)
Post Reply
antidartan
Posts: 15
Joined: Mon Sep 17, 2007 11:03 am
Location: ROCHESTER,ny

DISPASER QUESTION

Post by antidartan »

i am trying to build a tin can sterling engin. I have the preasure vessil and displacer built according to the plans. The displacer can travel high enough to go past the hole going to the power piston. Is that a problem or do i just make the crank shaft in such a way that it limits the throw of the dispacer? :-?

Thanks
Antidartan

[/quote]
VENI VIDI VICI
SScandizzo
Posts: 66
Joined: Tue May 16, 2006 5:06 pm
Location: California

Post by SScandizzo »

Hi Antidartan,

Welcome to the world of Stirling engines!

The displacer should travel the entire length of the displacer cylinder so that at either end of the cycle it is either almost touching the top or bottom of the cylinder. The location of the hole to the power cylinder is of little consequence in this design.

-Stefan
antidartan
Posts: 15
Joined: Mon Sep 17, 2007 11:03 am
Location: ROCHESTER,ny

displacer

Post by antidartan »

Thaks for the info. Exuse my spelling of displacer, wine does that to me:)
VENI VIDI VICI
antidartan
Posts: 15
Joined: Mon Sep 17, 2007 11:03 am
Location: ROCHESTER,ny

Post by antidartan »

On all the modles I have seen, the displacer is fairly thick. Is there a problem with the displacer being a thin piece of metal?
VENI VIDI VICI
Administrator
Owner
Owner
Posts: 95
Joined: Mon Jan 30, 2006 9:04 pm

Post by Administrator »

On a tin can engine........a thin piece of metal does not "displace" a lot of air. The job of the displacer is not that of a piston like in an engine, but to displace air from one side to the other. It needs volume to do that.

Maybe I should think about changing the name of the "displacer piston" to just "displacer"?? and leave the name "power piston" as is??

DB
SScandizzo
Posts: 66
Joined: Tue May 16, 2006 5:06 pm
Location: California

Post by SScandizzo »

Hi Antidartan,

The displacer moves air back and forth between the hot and cold ends of the displacer cylinder. The material it is made from should be as light as possible for two reasons: first, thinner material conducts heat less than thicker material and second, a lighter displacer requires less work to move it back and forth.

The VOLUME of the displacer is a different story. It should be a wide as the plans show because it must DISPLACE a large volume of air when it moves.

Hope this helps!

-Stefan
Post Reply